Stock piston pin seized up. Stuck on rod HELP!

*kingpin* · 2010-04-09T06:57:00Z

So I'm trying to remove my stock piston from my rod to install an 88 kit and I can't get the pin to slide out of the rod. Any suggestions? I have tried hammering it out with a socket and a hammer but its not budging

Linear Mode

Stock piston pin seized up. Stuck on rod HELP!

lucky13 Offline

Member

Posts: 90
Threads: 5
Likes Received: 0 in 0 posts
Likes Given: 0
Joined: Oct 2009

04-15-2010, 11:48 AM

yeah make a little press tool with a piece of all thread and a few sockets and a few nuts and then crank the nut down and should push the pin out same way a clymer book suggests ive had to do it and it worked on a different bike

Find

« Next Oldest | Next Newest »

Messages In This Thread

Stock piston pin seized up. Stuck on rod HELP! - by *kingpin* - 04-09-2010, 02:57 AM

Stock piston pin seized up. Stuck on rod HELP! - by StrictlyStunt - 04-09-2010, 02:58 AM

Stock piston pin seized up. Stuck on rod HELP! - by Crazy D - 04-09-2010, 08:24 AM

Stock piston pin seized up. Stuck on rod HELP! - by NME - 04-09-2010, 11:54 AM

Stock piston pin seized up. Stuck on rod HELP! - by lucky13 - 04-15-2010, 11:48 AM

View a Printable Version

Forum Jump:

Users browsing this thread: 1 Guest(s)

Stuntride.org is an independently operated fan-run community archive and revival project, built from publicly available historical content. It is not affiliated with, endorsed by, or operated on behalf of the current owner(s) of the Stuntride brand, trademarks, or Stuntride.com.

Login
Username:
Password:	Lost Password?
	Remember me