06-01-2015, 05:58 PM
So i took the sliders or pucks off on my lunch break and rode it around and it still vibrates like crazy at 7k rpms I don't get it. So tonight I'm going to take it apart and put it back together. Maybe something didn't seat right on there. I'm pretty sure its put together properly tho. I used the shorter bolt with the spacer on the left side and the longer bolt on the right side and tightened those to 30ft lbs like Son said. then I tightened the rod that goes through the swingarm till I squished through about half of the rubber pad and I also tightened the crossbar until it couldn't turn anymore comfortably. Is there a specific sequence I should tighten everything in? Like hand tight all bolts then start from back to front tightening down everything?