|
+++balancing driveshafts+++
|
09-17-2011, 01:01 AM
My bad for coming off as an ass. I know moving your U-joints into another position will often cause vibrations. If you take the driveshaft off at the U-joint, you have to mark everything to make sure you get it back on in the exact orientation. If not it will be out of phase. I think that most likely the problem is the shaft was not balanced properly to begin with.
-chris 
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
+++balancing driveshafts+++ - by I.C. - 09-14-2011, 05:30 PM
+++balancing driveshafts+++ - by stunt305 - 09-14-2011, 05:50 PM
+++balancing driveshafts+++ - by I.C. - 09-15-2011, 10:58 PM
+++balancing driveshafts+++ - by dlish - 09-15-2011, 11:43 PM
+++balancing driveshafts+++ - by dlish - 09-15-2011, 11:44 PM
+++balancing driveshafts+++ - by stunt305 - 09-15-2011, 11:46 PM
+++balancing driveshafts+++ - by dlish - 09-16-2011, 11:28 PM
+++balancing driveshafts+++ - by stunt305 - 09-17-2011, 01:01 AM
+++balancing driveshafts+++ - by drew"db"beck - 09-21-2011, 05:03 PM
+++balancing driveshafts+++ - by Rummel Autosport - 10-14-2011, 02:28 PM
+++balancing driveshafts+++ - by 99NaSvt - 11-25-2011, 10:12 AM
|
