09 ZX6R Tail Saver

[KYD]

Built this for my buddy. Tails on these bikes seem to be getting smaller and smaller. Hardly any room to stand anymore and there tails are almost all 3 piece deals now so they snap easier. So i came up with this for him. Came out pretty good i think. Thought id share it.

My buddy in the Fabrication department who cut out the parts for me has a sense of humor lol.

[SQUINTS]

Saw it on Facebook looks good. I made mine about that wide and still managed to kick off one of the side tail plastic pieces

[Duane S.]

Need to make it wider underneath the seat so u don't step down on it

[KYD]

not quite sure what you mean by step down onto it? He was standing up on it last night and it cleared the plastic on all sides and only flexed the plate a little bit, but it rests up against the rear seat when usuing it. you can still take the rear seat on and off...tho its a tricky but do-able lol.

[Duane S.]

On the front seat backsides the tails aren't that strong kinda hook underneath the seat

[KYD]

the front tabs on his tail sides are missing the push pins that hold them to the subframe so those pop out all the time anyways. He keeps his feet right over the rear seat so they don't get near the tail sides, this just gives him a stronger platform to stand on and a little more room, and at the same time keeping the stock slender/sleek look. Im powdercoating it tomorrow at work and then he's putting some surf pad on it.

[KELL3N]

Hey who's PayPal do I gotta send some money to, to have one of these bad boys sent to my house.

[KYD]

PM a member on here. I built it for his bike and he's selling all the parts off it.

[KYD]

Shit, might wanna tell ya his name here lol, his name on here is bones